RGBlink Q16pro Gen2 User Manual page 26

then press IN 1-16 to synchronize the input to the selected output ports.
ENTER Light on if Switch Mode is triggered. Push ENTER button again to
return to Matrix Mode. (more details please refer to
2.Used as confirm button under menu operation.
1.Push LOAD button to trigger Scene Switch Mode in standby mode. Press
OUT 1-16 to load saved presets. (Notice: only ONE scene can be selected at
the same time)
LOAD Light on if Scene Switch Mode is triggered. Push LOAD button again to
return to Matrix Mode. (more details please refer to
2.Used as direction key "Left" under menu operation.
1.Push SAVE button to trigger OSD Mode in standby mode. Press IN 1-16 to
load OSD 1 or OUT 1-16 to load OSD 2 to selected output port.
SAVE Light on if OSD Mode is triggered. Push SAVE button again to return to
Matrix Mode. (more details please refer to
2.Used as direction key "Down" under menu operation.
1.Default to enter the Matrix Mode after power on.
2.Initial state: All input and output button lights are OFF. Users need to
choose one input button first and then the corresponding output button
light will be ON. Users can press other output buttons for matrix switch.
3.Non-initial state ( matrix has been switched): One input has been selected,
and the corresponding output button light is ON. Users can press other
output buttons for matrix switch.
Q16pro Gen2
3.1.4.2 OSD
User Manual
3.1.4.3 Switch Mode)
3.1.4.4 Scene Mode)
Mode)
25