Table of Contents
Advertisement
Layer Adjustment：
There are two ways to adjust layer.
1. Use the bar under the interface.
Choose one layer and the bar shows its signal source,
type in position and size. Click Set to confirm.
2. Layer Scale and Crop.
Choose one layer needed to be adjusted, and type in its
position and size.
this icon means data related, when width is changed,
height will be changed as same proportion.
this icon means data not related, width and height
need to be filled respectively.
Quick
Quick is to set layer layout quickly.
1. Single Monitor： choose the output port you would like
to set
2. Single Board：choose the output board you would like
to set
3. All Monitors: set close or on
4. Layer Set: set layer layout
Users can drag and drop the source from the Signal List.
After setting, click <Set> to confirm and the layout will be
shown on the interface as shown in the right figure.
Q16pro Gen2
User Manual
60
Advertisement
Table of Contents
