Table of Contents
Advertisement
Engine Coolant Temperature Sensor
Sensor Specifications
Operating Temperature
Range
Resistance
Installation Torque
Knock (DET) Sensor
Knock Sensor Screw Torque:
168 in-lbs (19 Nm) Install screw clean and dry.
-22°F - +248 °F
(-30°C - 120°C)
2.4 - 2.6K@ 68°F (20°C)
(Measure in stirred water)
29 ft-lbs (39.2Nm)
= T
Cleanfire Fuel Injection
Throttle Body Removal
1. Remove the oil tank/clutch cover assembly.
2. Remove the airbox assembly.
3. Pinch off the coolant lines with the hose pincher tool
PN PU-45149.
4. Remove the coolant hoses from the throttle body.
Disconnect the TPS harness connector.
5. Loosen the intake boot clamps and pull the throttle
body upward. Locate the oil pump linkage arm. Pop
the rod end off the throttle body cam.
6. Loosen the throttle cable lock nut and remove the
cable from the throttle body.
7. Remove throttle body.
8. During installation, verify the oil pump lever is not
rotated over-center before installing the linkage arm
on to the throttle body.
4
4.17
Advertisement
Chapters
Table of Contents
Troubleshooting
