Polaris 600 RUSH 2010 Manual page 324

Steering and Suspensions
Front Suspension Type by Model
FRONT SUSPENSION
Pro-Ride
Pro-Ride (Fixed Camber)
Pro-Ride RMK Adjustable RMK/Pro RMK
Pro-Ride Wide Adjustable RMK Assault
Rear Suspension Type by Model
REAR SUSPENSION
Pro-Ride Progressive 120 2010 Rush
Pro-Ride Progressive 121 Rush
Pro-Ride Progressive 136 Switchback
Switchback 144
RMK Coil Over 155/163
INDY 121
8.4
MODELS
2010-2011Rush/
Switchback Assault
2012-2013
Rush/Switchback/
Switchback Assault
600 INDY
MODEL
Switchback Assault
RMK/Pro RMK/RMK
Assault
600 INDY
Camber / Toe Specifications
Maximum width and camber measurements are achieved
with the front end elevated and shocks at full extension.
Toe alignment is measured at ride height. This means that
the machine is on the ground and resting at normal ride
height, not full rebound. Measure at a point 10" (25.4cm)
forward of the ski mount bolt and 10" (25.4cm) behind the
ski mount bolt, preferably on the center line of the carbide
skags.
Maximum width is measured from the center of the
spindles unless noted otherwise.
Camber measurement is taken from the top of the
alignment bar to the top of the ski mount hole in the spindle
with the bushing removed.
NOTE: Only models featuring upper control arms
with rod ends allow camber adjustments.
Camber & Toe Specifications
MAXIMUM
SET UP
SUSPENSION WIDTH in/cm
(± .25in/
.6cm)
Pro-Ride
41.52/105
Pro-Ride
(Fixed
Camber)
Pro-Ride RMK
Adjustable
2011-2012
2013
36.26/92
(Measured
36.85/93.6
inside of
spindles)
Pro-Ride Wide 38.58/98
Adjustable
TOE OUT
CAMBER (At ride
in/cm height)
in/cm
1.68 ± .31
(4.2 ± 0.8)
N/A
0 -.12
(0 -0.305)
1.95  0.31
(4.3  0.8)
2.25  0.31
(5.7  0.8)