Progressive Rear Suspension Removal And Installation; Removal - Polaris 600 RUSH 2010 Manual

PROGRESSIVE REAR SUSPENSION
REMOVAL AND INSTALLATION

Removal

1. Place a large mat, shop blanket, or piece of
cardboard on the floor next to the snowmobile. The
piece should be large enough to protect the plastics
when the unit is laid on its side.
2. Remove the rear bumper assembly from the rear
crank.
BUMPER FASTENERS
3. Loosen, but do not remove, the rear idler wheel
fasteners.
4. Loosen the track tension adjuster jam nuts. Back out
the threaded adjusters until flush with adjuster blocks.
REAR IDLER FASTENER
5. Using a snowmobile lift, raise the vehicle high enough
off the ground to remove the vehicle weight from the
rear suspension.
6. Remove the upper carrier wheel assembly from the
7. Remove the two fasteners and nuts securing the rear
REAR IDLER FASTENER
TRACK TENSION ADJ.
8. The rear of the suspension is now free to drop out of
Steering and Suspensions
rear crank.
pivot to the rear crank.
the tunnel if required.
UPPER CARRIER
8
PIVOT FASTENER
8.75