Exhaust Systems; Pro-Ride Dc-Cfi-4 Exhaust System - Polaris 600 RUSH 2010 Manual

EXHAUST SYSTEMS

PRO-RIDE DC-CFI-4 Exhaust System

ZINC-PLATED (YELLOW) SPRINGS
MOUNT BUMPER
(INSTALL LARGE END TO OUTSIDE)
EXHAUST PIPE
A: EGT Sensor: 32 ft-lbs (44 Nm) Apply anti-seize to
threads.
B: Exhaust Manifold Fasteners: 22 ft-lbs (30 Nm)
C: Silencer Rubber Mount Fastener = 17 ft-lbs (23 Nm)
D: Silencer Bracket Fasteners = 26 ft-lbs (35 Nm)
NOTE: Always use the stainless steel (gray) springs
to connect the exhaust pipe to the exhaust manifold.

HEAT SHIELD
C
A
STAINLESS STEEL (GRAY) SPRINGS
= T
Engine/Cooling/Exhaust
GASKET
D
GASKETS
B
When removing the exhaust pipe, disconnect the EGT
probe wire harness. Do not remove the EGT probe
from the pipe if not necessary.
HEAT SHIELD
EXHAUST SEAL
3.51
3