Polaris 600 RUSH 2010 Manual page 149

16. Reinstall the steering drag link with the rod ends
parallel to each mating surface. Torque nuts to
specification.
Steering Drag Link Rod End Nuts: 37 ft-lbs (50 Nm)
17. If the snowmobile is equipped with electric start,
reinstall the battery and reconnect the battery cables.
Connect BLACK negative (-) cable first, and then RED
positive (+) cable last.
CAUTION
Attach the RED (+) battery cable first, and then the
BLACK (-) cable last.
18. Reinstall the exhaust silencer. Verify the silencer
outlet tube is installed in the fender boot and that the
boot has not been pushed out of the fender.
19. Torque the silencer rubber mount fastener to
specification.
= T
Engine/Cooling/Exhaust
NOTE: Install the silencer mount rubber dampener
with the fat end facing outwards.
SILENCER MOUNT
Silencer Mount: 17 ft-lbs (23 Nm)
20. Reinstall the exhaust pipe. Verify the gray springs are
installed at the pipe-to-manifold locations.
21. Reconnect the over structure electrical component
wire harness connections. Verify the white harness
bands are routed so they can be fitted into each
respective harness retainers.
22. Clean the PTO clutch taper with emery cloth. Reinstall
the drive clutch. Torque fastener to specification.
Drive Clutch Bolt Torque: 80 ft-lbs (108 Nm)
Re-torque after running engine.
= T
= T
3.39
3