Table of Contents
Advertisement
Digital Wrench® Communication Errors
If you experience problems connecting to a vehicle or any
Digital Wrench® related problem, visit the Digital
Wrench® Knowledge Base for the most current
troubleshooting information, FAQs, downloads and
software updates at:
http://polaris.diagsys.com/.
Digital Wrench® - Diagnostic / Power
Connectors
The diagnostic/power connectors are located behind the
left engine compartment door.
1. Assemble the SmartLink Module and attach the PC
Interface Cable to your PC/laptop.
Cleanfire Fuel Injection
2. Remove the protective cap from the Digital Wrench®
connector (A) and then connect the Vehicle Interface
Cable to the diagnostic connector.
A
3. Connect the chassis power-up harness to a fully
charged 12VDC battery. Connect the chassis power-
up harness to the ECU POWER connector.
NOTE: An internal relay within the harness prevents
reverse polarity damage in the event the alligator
clamps are connected to the battery incorrectly.
CHASSIS POWER-UP HARNESS
PS-47296-A
DUAL PWR/FUEL PUMP PRIME
PS-50805
4. When battery power is connected successfully, the
SmartLink status LED will blink on once.
ECU POWER
4.35
4
Advertisement
Chapters
Table of Contents
Troubleshooting
