Throttle Cable Routing; Steering / Suspension Maintenance; Handlebars - Polaris 600 RUSH 2010 Manual

Table of Contents

NOTE: Never use the in-line adjuster to adjust engine

idle speed. Never adjust the cable so that the throttle

plate cam on the throttle body no longer rests against

the idle air gap screw.

Turning the in-line adjuster inwards (clockwise) will

increase throttle lever free-play.

Turning the in-line adjuster outwards (counter-clockwise)

will decrease throttle lever free-play.

After setting the throttle lever free play, always verify the oil

pump adjustment is set correctly.

Throttle Cable Routing

Route the throttle cable as shown in the photo. Turn the

handle bars to the full left and right positions with the

engine running to verify the engine RPM does not increase

as the bars are turned.

ROUTE THROUGH

STEERING / SUSPENSION

Periodically inspect the torque of the handlebar clamp

STEERING POST

1. To adjust the handlebar angle, remove the handlebar

cover, if equipped, to expose the upper clamp.

2. Loosen the four clamp fasteners. Slightly pry the

upper clamp up with a flat blade screwdriver.

RISER ("FWD" FACES FRONT)

STEERING POST

INDY/RUSH/SWITCHBACK/RMK

PRO RMK/RMK ASSAULT

Table of Contents