Exhaust Valve Solenoid; Ignition Coils - Polaris 600 RUSH 2010 Manual

Cleanfire Fuel Injection
2. Insert the blade of a .030" feeler gauge between the
rib and sensor face. If there is no drag felt on the feeler
gauge, the CPS must be adjusted.
3. To adjust a CPS, use an 8 inch pry bar to carefully
deflect the sensor.
4. Place the tip of the small pry bar between the back of
the sensor and crankcase. insert a .012" feeler gauge
between the sensor face and encoder rib.
IMPORTANT: Do not pry on the individual sensor
wires.
PRY BAR
5. Gently pry the sensor towards the encoder rip until the
gauge begins to bind between the components.
6. Re-measure the air gap. The gap should be between
.020-.030.
4.16
FEELER GAUGE

Exhaust Valve Solenoid

Specifications
Coil Resistance
(WHT/YEL to RED)

Ignition Coils

Specifications
Primary Coil
Resistance
(Black to White)
Secondary Coil
Resistance
(Without Plug Cap/
Black to High Tension
Lead)
Plug Cap Resistance
15 +/- 15% @ 68°F (20°C)
DC-CFI 4 DC-CFI 2
0.20 +/- 15% 0.45 +/- 15%
@ 68°F (20°C) @ 68°F (20°C)
6.3k +/- 15% 18k +/- 15%
@ 68°F (20°C) @ 68°F (20°C)
5k+/- 15% @ 68°F (20°C)