Gema MagicCompact BA04 Operating Instructions And Spare Parts List page 7

MagicCompact BA04
V 06/13
7. The connecting cables between the control unit and the spray
gun must be installed so as to eliminate the possibility of damage
during the operation. Please observe the local safety regulations!
8. Only original Gema spare parts should be used, because the
explosion protection will also be preserved that way. Any
warranty claim for damage caused by the use of foreign parts is
void.
9. If Gema Switzerland GmbH powder spraying equipment is used
in conjunction with machinery from other manufacturers, then
their safety regulations must also be taken into account.
10. Before starting work, familiarize yourself with all installations and
operating elements, as well as with their functions!
Familiarization during operation is too late!
11. Take care when working with a powder/air mixture! A powder/air
mixture in the right concentration is flammable! Smoking is
forbidden in the entire plant area!
12. As a general rule for all powder spraying installations, persons
with pacemakers should never enter high voltage areas or areas
with electromagnetic fields. Persons with pacemakers should not
enter areas with powder spraying installations!
WARNING!
We point out that the customer himself is responsible for the safe
operation of the equipment. Gema Switzerland GmbH is in no way
responsible for any resulting damage.
Safety conscious working
Each person responsible for the assembly, start-up, operation, service
and repair of powder spraying equipment must have read and
understood the operating instructions and the "Safety regulations"
chapter. The operator must ensure that the user has had the appropriate
training for powder spraying equipment and is aware of the possible
sources of danger.
The booth should only be used by trained and authorized personnel. This
applies to modifications to the electrical equipment, which should only be
carried out by a specialist.
The operating instructions and the necessary closing down procedures
must be followed before any work is carried out concerning the set-up,
start-up, operation, modification, operating conditions, mode of operation,
servicing, inspection or repairs.
The booth can be turned off by using the main switch or failing that, the
emergency shut-down. Individual components can be turned off during
operation by using the appropriate switches.
Individual safety regulations for the operating
firm and/or operating personnel
1. Any operating method, which will negatively influence the
technical safety of the powder spraying equipment, is to be
avoided.
General safety regulations • 5