Gema MagicCompact BA04 Operating Instructions And Spare Parts List page 33

MagicCompact BA04
V 06/13
5. Coarse cleaning of the booth
Coarse cleaning of the booth with the air lance
-
Open the cyclone cone and remove the sieve, leave the
-
cyclone open
Remove the recovery hose from the powder container
-
6. Clean the booth
if necessary, move the guns out of the booth
-
if necessary, clean the muzzles etc.
-
Blow off the booth with the air lance, clean the suction
-
opening
if necessary, wipe off the booth walls
-
7. Clean the powder center
if necessary, change the powder hoses (bright/dark)
-
Initiate the filter cartridges cleaning manually
-
Clean the powder center (floor, vibrating table, collecting
-
container etc.)
8. Clean the recovery system
Connect the recovery hose to the blow off connector
-
Open the cyclone cone and clean the sieve
-
Blow off the recovery system
-
if necessary, wipe off the cyclone cone
-
Blow off the inside of the monocyclone with the air lance
-
9. Prepare the equipment for coating
Make the recovery system ready for operation
-
Put the powder center into coating operation (insert the
-
powder container with the new color, move down the
injectors)
Put the booth into coating operation (switch on the plant,
-
move the XT axis into coating position, start the correct
reciprocators program)
10. Check the guns for functioning (high voltage and powder
output)
Remark:
This short instructions should facilitate, above all, the handling of the
plant for the daily, always recurring works. They do not replace by any
means the enclosed manuals of the components, and presuppose that
you read and understand the corresponding chapters in the operating
manual as well as the safety regulations.
Operation • 31