Gema MagicCompact BA04 Operating Instructions And Spare Parts List page 36

Maintenance and repair of the cyclone separator
Maintenance and repair of the sieve machine
Maintenance of the After Filter pressure gauges (filter
and fan)
Replacing spare parts
34 • Maintenance
V 06/13
The following activities on the cyclone should be carried out regularly:
Remove powder deposits and caked powder
-
Check the gaskets, sealing strips and locking mechanisms
-
(covers etc.) for functioning and sealing
Replace the material abraded from the cyclone inside walls
-
by abrasive powders (by build-up welding)
Further information, see the corresponding operating manual!
The following activities on the sieve machine should be carried out
regularly:
Check the gaskets and if necessary, replace them
-
Check the clamping force of the clamping levers and if
-
necessary, reset them
Clean the sieve mesh, or if damaged, replace it
-
Further information, see the corresponding operating manual!
The following check should be carried out regularly:
Notice the pressure on the pressure gauges and compare
-
with the original pressure values, which were set by the
Gema service engineer at the first start-up
If errors arise, see the troubleshooting guide and the After
-
Filter operating instructions
If it is not possible to adjust the original settings, please
-
contact an Gema service center
Further information, see the corresponding operating manual!
Spare parts are to be replaced by trained personnel only. The plant must
always be switched off, when replacing spare parts. Spare parts can be
ordered from the spare parts list.
Note:
Only original Gema spare parts should be used!
MagicCompact BA04