Gema MagicCompact BA04 Operating Instructions And Spare Parts List page 6

Technical safety regulations for stationary
electrostatic powder spraying equipment
4 • General safety regulations
V 06/13
3. Observance of the operating, service and maintenance
instructions specified by the manufacturer is also part of
conformity of use. The MagicCompact BA04 powder coating
booth should only be used, maintained and started up by trained
personnel, who are informed about and are familiar with the
possible hazards involved.
4. Start-up (i.e. the execution of a particular operation) is forbidden
until it has been established that the MagicCompact BA04
powder coating booth has been set up and wired according to
the guidelines for machinery (2006/42 EG). EN 60204-1
(machine safety) must also be observed.
5. Unauthorized modifications to the MagicCompact BA04 powder
coating booth exempts the manufacturer from any liability from
resulting damage.
6. The relevant accident prevention regulations, as well as other
generally recognized safety regulations, occupational health and
structural regulations are to be observed.
7. Furthermore, the country-specific safety regulations also must be
observed.
Explosion protection
General information
Stationary Gema Switzerland GmbH electrostatic spraying equipment is
built to the "state of the art" and is operationally safe. This equipment can
be dangerous if it is not used for its specified purpose. Consequently it
should be noted that there exists a danger to life and limb of the user or
third party, a danger of damage to the equipment and other machinery
belonging to the user and a hazard to the efficient operation of the
equipment.
1. The powder spraying equipment should only be started up and
used once the operating instructions have been carefully studied.
Incorrect operation of the control unit can lead to accidents,
malfunctions or damage to the control itself or to the plant.
2. Before every start-up check the equipment for operational safety
(regular servicing is essential)!
3. The local safety guidelines are to be followed for safe operation.
4. Please observe the local safety regulations!
5. Disconnect the plugs before the machines are opened for repair.
6. The plug connections between the powder spraying equipment
and the mains should only be removed when the power supply is
switched off.
Protection type
II 3D
MagicCompact BA04
IP54