Product Dimensions - Measurements In Mm; Positioning The Appliance - Smeg GW1160 User Manual

11 PRODUCT DIMENSIONS - MEASUREMENTS IN mm

The appliance can be requested with top for built-in installation for special requirements.
In this case, the product is 30 mm shorter than the stated height.
VERSION
STANDARD
STANDARD + AQUASTOP
STANDARD + PAD1
STANDARD + P3

12 POSITIONING THE APPLIANCE

IMPORTANT
The appliance must be positioned with its back near a wall (with a gap of at least 10 mm) and must be installed by an
authorised SMEG engineer.
The installer engineer is responsible for the correct operation of the appliance after installation and must also
provide the user with all information required for its correct use.
During installation, the protective film must be removed from the steel outer surfaces.
The set of installation accessories (seals and hose ties) is inside the chamber.
The appliance can be installed with its sides flush against those of the adjacent cabinets, taking care not to obstruct
the steam vent on the rear. The wall at the back should be in masonry or another waterproof material.
Also take care that the heat does not reach any electrical circuits or sockets behind the appliance.
The appliance has water intake and drain hoses which can be positioned leading to the right or left, depending on
installation requirements.
If ordered in the appropriate version, the appliance can be installed built under a worktop; installation must be carried
out by skilled staff.
LEVELLING
After positioning the appliance, screw the feet down or unscrew them to adjust its height and level with the aid of a
spirit level so that it will be perfectly horizontal (max angle tolerance allowed: 0.5 °, corresponding to a maximum
permissible difference in height between opposite corners of the appliance of about 5 mm).
Correct levelling will ensure that the appliance operates correctly.
User Manual
fig. 44 – Product overall dimension diagram
A B
600 600
600 600
710 600
660 600
GW1160 - GW4060 Series
C D
30 600
30 600
30 600
30 600
E
F
850
> 10
857
> 10
850
>10
850
> 10
Page 65 - 75