Related Manuals for Smeg LST107-2
Summary of Contents for Smeg LST107-2
- Page 1 LAVATRICE WASHING MACHINE LAVE-LINGE WASCHVOLLAUTOMAT LAVADORA LIBRETTO ISTRUZIONI INSTRUCTION MANUAL MANUEL D'INSTRUCTIONS GEBRAUCHSANLEITUNG MANUAL DE INSTRUCCIONES...
-
Page 2: Table Of Contents
Contents 1. Precautions for safety and use 2. Installation instructions 3. Description of controls 4. Using the appliance for washing 5. Cleaning and maintenance 6. Troubleshooting This appliance is tagged in accordance with European Directive 2002/96/EC on Waste Electrical and E- lectronic Equipment - WEEE. -
Page 3: Precautions For Safety And Use
READ THE INSTRUCTIONS Attention! You are advised to read all the instructions in this manual carefully; it will inform you about the right conditions for the proper, safe use of your washing machine. It is very important to keep this instruction manual with the appliance for future ref- erence. - Page 4 same as the values marked on the nameplate. The use of adapters or junctions is not recom- mended. Never disconnect the plug by pulling on the power supply lead. The appliance is only disconnected from the electricity supply if the plug has been removed •...
- Page 5 For Great Britain only Warning: this appliance must be earthed. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1.
-
Page 6: Installation Instructions
2. INSTALLATION INSTRUCTIONS Important! The appliance must be installed by a qualified engineer in compliance with the relevant regulations. The washing machine is heavy. Take care when lifting it. 2.1 UNPACKING The unit on flexible mounts is fixed in place for transport using the screws (A) on the rear of the washing machine with the relative plastic spacers (B). - Page 7 2.2 POSITIONING AND LEVELLING 1. Place the appliance in the chosen position. Level the appliance carefully in all directions with the aid of a spirit level, adjusting the height of the feet if necessary. Once done, fix the feet in pla- ce with the locknuts provided.
- Page 8 2.3 CONNECTING TO THE WATER SUPPLY Check that the water supply pressure is in the following range: 0,05-0,9MPa. With higher pressures, use a pressure reducer. Connect the cold water supply hose (blue screw collar) to the cold water tap with ¾ gas threaded connector, taking care to tighten firmly to prevent leaks.
-
Page 9: Description Of Controls
If the power supply lead is damaged, it must only be replaced with an original spare, available from the After- • Sales Service. Do not connection/disconnect the power supply plug from the socket with wet hands • Only disconnect the power supply plug from the socket by taking hold of the plug itself, never by •... -
Page 10: Using The Appliance For Washing
4. USING THE APPLIANCE FOR WASHING 4.1 PREPARING THE ITEMS FOR WASHING Subdivide the items for washing by fabric type and colour fastness. Wash white and coloured items separately. New coloured items should be washed separately the first time. Normally, items carry labels with washing instructions. The following is a short description of the symbols u- sed on these labels. - Page 11 4.4 LOADING THE ITEMS FOR WASHING Open the door and load the washing, distributing it evenly over the drum, with items opened out and not bundled together; if possible, large and small items should be well mixed. The washing machine covered by this manual can be loaded with up to 7kg of washing for each wash. If this weight is exceeded, the washing results will be poor and the appliance may malfunction.
- Page 12 4.6 POWDER DETERGENT DOSES Laundry with normal dirt Choose a programme without prewash. Pour the total amount of detergent shown on the pack into the main wash compartment of the detergent dra- wer. Very dirty laundry Choose a programme with prewash. Place ¼...
- Page 13 4.11 SELECTING AND CONFIRMING OPTIONS Options Start Pause Confirm option Option selection The Option Selection button can be used to select the following options in sequence (from the top down): Prewash: adds a stage before the main wash, lasting about 20 minutes at a temperature of 35°C. Suit- able for loads of particularly dirty items.
- Page 14 4.12 TIME TO END Delay Time to end Start pause symbol Start Pause Delay Time to end The Time to End key can be pressed repeatedly to select the time after which the washing programme will end. The time to end of cycle function calculates the initial duration of the washing cycle, the settings made (temperature, spin speed and options) which may shorten or lengthen the cycle's initial duration, and the delay time the user wishes to add before the cycle starts.
- Page 15 4.15 PROGRAMME END Washing programmes are completed automatically. The word END appears on the display and the "Time remain- ing" light goes out. Switch the appliance off by turning the programmes knob to OFF Unload the laundry from the drum. Leave the door ajar to allow the interior of the washing machine to dry out.
-
Page 16: Cleaning And Maintenance
5. CLEANING AND MAINTENANCE Important – Before carrying out any cleaning or maintenance procedure, the plug must be disconnected from the power supply socket. 5.1 CLEANING THE OUTSIDE OF THE APPLIANCE Regular, thorough cleaning will keep your appliance looking good. •... - Page 17 3. Extract the drain hose ”A”. Warning: if the hose is hot, the water is hot or boiling hot. Place a shallow container on the floor and remove the plug “B” to drain off the water. Depending on the amount of water in the appliance, the container may have to be emptied several times.
-
Page 18: Troubleshooting
6. TROUBLESHOOTING This produce complies with the relevant regulations governing the safety of electrical equipment. For safety rea- sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user. If the appliance does not work, before calling the After-Sales Service, to avoid unnecessary expense, check your- self that the operations listed in this troubleshooting table have been carried out. - Page 19 Appliance does not spin Anti-imbalance safety device tripped because laundry not evenly distrib- uted in drum. If laundry is still wet at end of cycle, rearrange it in the drum by hand and repeat spin programme only. Emptying water from drum In the event of a power blackout or appliance failure, the water can be removed from the drum using the emergency procedure.
- Page 20 PROGRAM GUIDE Detergent drawer compartments Options Programs Temp. Max. Spin Max. Prewash Wash Conditioner Prewash Intensive Easy Extra rinse Rapid Wash program description (° C) (rpm) washing Iron load (kg) Delicate coloureds with Cotton Cold wash, rinses and final spin at the selected speed light dirt Delicate coloureds with Wash at 40°...
- Page 23 • •...
- Page 25 820mm 560mm 596mm 820mm 58mm ca. 82kg 150mm 16mm...
- Page 26 3 - A 11 11 3 - B...
- Page 27 Unterkante Unterkante Lower edge Lower edge Côté inférieur Côté inférieur Lato inferiore Lato inferiore Lado inferior Lado inferior Onderkant Onderkant 16...21mm 16...21mm ижний к ай ижний к ай 592...595mm 592...595mm Ø 35mm Ø 35mm Ø 2mm Ø 2mm...