Table of Contents
Advertisement
5.1 PROGRAMMING THE BOARD
When the display shows the automation status, you
can enter basic, advanced or expert programming
mode.
■ Basic programming
F F
1. Press and hold the
the first function (
which is displayed as long as button F remains
pressed.
2. Release the button: the display shows the value
of the function.
+ +
or - - button to modify, then press the
3. Press the
F F
button to confirm to go to the next function.
Proceed in the same way for all the functions.
■ Advanced programming
1. Press and hold the
as well: the first function (
display, which is displayed as long as button
remains pressed.
2. Release the buttons: the display shows the value
of the function.
+ +
or - - button to modify, then press the
3. Press the
F F
button to confirm to go to the next function.
Proceed in the same way for all the functions.
■ Expert programming
i
Before making changes at this level, make sure that you
fully understand the effect that the changes might have.
If you modify functions relating to the operating logics,
a custom logic is created (in basic programming the LO
function will display CU).
1. Press and hold the
as well for about 10 seconds: the first function (
appears on the display, which is displayed as long
F F
as button
remains pressed.
2. Release the buttons: the display shows the value
of the function.
+ +
or - - button to modify, then press the
3. Press the
F F
button to confirm to go to the next function.
Proceed in the same way for all the functions.
B680H
button:
CC
) appears on the display,
F F
+ +
button, then the
button
bo
) appears on the
F F
+ +
button, then the
button
■ Exiting programming mode
i
Every modified value becomes effective immediately,
but when exiting from programming mode you have to
decide whether to save the modifications or not.
Modifications are lost if no buttons have been pressed
for 10 minutes or if power to the board is disconnected
before they have been saved.
1. Press and hold down the
button as well.
Alternatively, scroll through the programming
menu until you reach the last function (
2. Select:
Y
= save the changes
no
= DO NOT save the changes
3. Press button
the automation status view.
F F
01
)
29
F F
button, then the + +
F F
to confirm: the display reverts to
St
).
732719 - Rev.E
Advertisement
Table of Contents
