Table of Contents
Advertisement
4.2 CONNECTIONS
CONTROL DEVICES (J1)
J1
3 4 5 6 7 8 9
i
Multiple NO contacts on same input must be connected
in parallel.
Multiple NC contacts on same input must be connected
in series.
Below is a brief explanation of the inputs. The effect a
command has may vary according to the operating logic
and programming functions.
NO contact, connect a button or other pulse giver
3
OPEN
that commands the opening of the barrier, by
closing a contact
NO contact, connect a button or other pulse giver
4
CLOSE
that commands the closure of the barrier, by
closing a contact
NC contact, connect a photoelectric cell or other
device that commands the inversion on opening,
by opening a contact during the closure
5
FSW
i
If NO device is connected, make a jump
with GND
NC contact, connect a button or other pulse giver
that commands the stopping of the barrier, by
opening a contact
6
STOP
i
If NO device is connected, make a jump
with GND
NC contact, connect a button or other pulse giver
that commands the emergency opening of the
barrier, by opening a contact
7
EMR
i
If NO device is connected, make a jump
with GND
Accessories power supply negative and common
8-9
GND
contacts
10-11
+
Accessories power supply positive 24 V
i
Do not exceed the maximum load of the accessories
(see Board technical data). To calculate the power
consumption, refer to the instructions of the individual
accessories.
B680H
OUTPUTS (J2)
11
10
■ OUT 1-2-3
i
Open Collector Outputs: the activation of the output
and its polarity can be configured by Advanced pro-
gramming.
NO polarity
NC polarity
■ OUT 4 a relè
i
EXTERNAL FLASHING LIGHT 24 V
Connect a 24 V XLED external flashing light to these
terminals.
"
25
12 13 14 15 16 17 18 19
J2
Do not exceed the maximum load of 24 V
for each output.
OUT active
"
0 V
open circuit
The maximum load for each output is 500 mA at 24
"
V
.
24 V "
4.8 W max
20
21
"
with 100mA
OUT not active
open circuit
"
0 V
"
(J3)
J3
732719 - Rev.E
Advertisement
Table of Contents
