Table of Contents
Advertisement
5. START-UP
Carry out the following operations referring to the §
specific sections.
1. Make sure that the barrier B680H is locked and not
operating in manual mode.
2. Switch on power to the system. The board lights
up and the display then comes on:
- firmware version (2 digits separated by a point).
SO
-
flashing if setup is requested, or the automa-
tion status.
i
If two barriers are installed in a Primary-Secondary con-
figuration, the Secondary barrier has to be configured
before you start to set up the Primary barrier (see § 8.1).
DL15
DL2
DL12
DL13
3 4 5 6 7 8 9
2EASY
B680H
RP/DECODER
DL9
S.O.
SW1 SW2 SW3
DL14
11
12 13 14 15 16 17 18 19
20
10
3. Check the status of the LEDs, with the board pow-
ered and closed, some LEDs will be on, others will
be off (refer to 2 4 )
4. Memorise the radio controls of the system (see
relative instructions).
5. Program the E680S without carrying out the set-
up. In order for the barrier to work properly, set
cF
function
6. Check the direction of movement.
7. Carry out the setup procedure.
8. If you use an XBAT 24 battery, connect the battery
after having carried out the setup. Connect it
with the power supply disconnected.
CAL1 CAL2
21
24 25 26 27
28
according to the length of the beam.
24
732719 - Rev.E
Advertisement
Table of Contents
