Table of Contents
Advertisement
2
1
1
3
Fig. - Drain plugs
1. Hexagon nut
2. Hose
3. Drain plug
2020-01-06
Maintenance - Every 50 hours
Weekly (Every 50 hours of operation)
Park the roller on a level surface.
When checking and adjusting the machine,
always turn off the engine and make sure the
forward/backward lever is in the neutral position.
When the engine is off in enclosed places,
make sure there is a good ventilation, to
prevent carbon monoxide poisoning.
Replace the Diesel engine oil
The engine oil drain plug is on the rear of the machine, on the
right side. Its access can be found when opening the panel in
front of the exhaustion duct.
Drain the oil when the engine is still hot and put a container
with minimum capacity of 3.69 gal (14 liters) under the plug.
Be extremely careful when draining the oil. Use
gloves and protective goggles to prevent the
hot oil getting in contact with the skin, which
can cause burns.
1. Remove the hexagon nut (1), take off the hose (2) and
loose the oil drain plug (3).
2. Let all the oil come out to the container and when the
operation is done, fix the drain plug (3) back to its place
and fit the hose (2) back again.
3. Next, tighten the hexagon nut.
TAKE CARE OF THE ENVIRONMENT: All the
used
oil
subsequent disposal. Do not dispose of oil on
the ground, sewage system or other place
which can harm the environment.
Always fill with new oil. For correct grade oil information, refer
to the Lubricant specifications or the Engine Manual
Instructions. Fill according to the oil volume necessary to the
engine. Check the dipstick to know if the volume is correct and
before carrying out the operation, let the engine in idle for a
few minutes and turn it off.
4812314580EN
shall
be
properly
stored
for
93
Advertisement
Table of Contents
