Table of Contents
Advertisement
1
2
Fig. - Hydraulic oil tank
1. Tank cap
2. Sight glass
1
2
Fig. - Front of the cab.
1. Air filter (1x)
2. Bolt (2x)
108
Maintenance - Every 1,000 hours
Replace the hydraulic oil filters
The hydraulic filters are located on the left side of the engine
compartment, behind the battery switch.
TAKE CARE OF THE ENVIRONMENT: All the
used
subsequent disposal. Do not dispose of oil
on the ground, sewage system or other place
which can harm the environment. The filter is
disposable and cannot be cleaned.
1. Open the hydraulic oil tank cap (1).
2. Clean carefully the sealed surface on the filter holder.
3. Apply a thin layer of clean hydraulic oil on the rubber
gasket of the new filter.
4. Fit manually the filter, first until the filter gasket manages
to reach the holder. Next, tighten it with one more turn.
5. Check the hydraulic oil level on the sight glass (2) and
adjust, if necessary. Refer to the section "Every 10 Hours"
to obtain further information.
6. Turn on the engine and check if the filter is well sealed.
Replace the cab air filter
There is an air filter (1) on the left side of the cab. To replace it,
follow the instructions below:
1. Open the protective cap.
2. Unscrew the bolts (2) and remove the entire holder.
Remove the filter element and replace the filter for the
new one.
2
3. If the machine works in places with excessive dust, it may
be necessary to replace the filter more frequently.
4812314580EN
oil
shall
be
properly
stored
for
2020-01-06
Advertisement
Table of Contents
