Fayat Group Dynapac CP2100 Instruction Manual page 101

Pneumatic tire roller
Table of Contents

Advertisement

Fig. – Air filter
1. Backup filter
1
Fig. – Engine compartment
1. Filter
2020-01-06
Maintenance - Every 50 hours
Check and replace the secondary air filter
Replace the backup filter when the main air filter is
replaced for the third time.
To replace the backup filter for a new one, follow the
instructions below:
1. Remove the old backup filter (1) from the holder, install a
new on and fit the components back in the reverse order.
2.
Clean the main filter, if necessary.
Replace the engine fuel filter
The fuel filter is located in front of the accumulators, on the left
side of the engine compartment.
1. Unscrew the bottom of the filter and drain the water. Next,
screw the unit back in its place.
2. Fit the fuel filter in the correct place, turn on the engine and
check if the filter is well sealed.
4812314580EN
95

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dynapac cp2100w10000511clc00961910000516vlc009620

Table of Contents