Fayat Group Dynapac CP2100 Instruction Manual page 12

Fig.: Operating on downhills.
6
Safety - When operating
Avoid people entering at the danger area, that is, at a
distance of at least 23 ft (7 m) in all the directions from
the machine operating. The operator can allow one
person to be at the danger area, but in this case, care
must be taken and the machine can only be operated
when this person is in a visible place or with clear
indication of where he/she is.
Operating on slopes
The machine must never be operated from the
outside of the cab. The operator shall be seated
when operating.
Slopes
This angle was measured on a flat, hard surface and with the
machine in a stationary position.
The steering angle is zero, the tires pressure is normal and all
the tanks are full.
Always remember that loosen ground, the steering of the
machine, different tire pressures, the operation speed and the
gravity center raising may cause the machine to turn, even on
slopes smaller than the ones stated here.
If you need to leave the cab in emergency
situations, take off the hammer at the rear pillar on
the right and break the opening windows that are
also on the right.
It is recommended
Protective Structure) is always used when driving
on slopes or unsafe ground.
Whenever possible, avoid driving across slopes.
On slopes, drive straight up and down.
The speed must always be slow when operating
on slopes.
Always operate the machine with the doors closed
and with the seat belt.
4812314580EN
Safety
Max. 20º
or 36%
that ROPS (Roll
2020-01-06
Over