Setting The Audio Tone - Xerox DocuColor 2060 Maintenance Manual

Default settings for the printer engine

Setting the audio tone

7-12
There are three types of audio tones that can be activated on the
printer:
• Attention tone: This tone indicates that an unselectable
button has been touched or pressed.
• Button Selection tone: This tone indicates that a selectable
button has been touched or pressed.
• Fault tone: This tone indicates that the printer is in a fault
condition and cannot continue printing.
Each of these tones can be deactivated or set to Soft, Normal, or
Loud. The factory default setting is Normal.
To set the audio tone:
1. Access the Tools mode (refer to the section "Accessing the
Tools mode" in this chapter).
2. On the Machine Default 1 screen, touch the Audio Tones
button. The Audio Tones screen displays.
Figure 7-13. Audio Tones screen
3. Touch the button for the desired volume setting for each tone.
To deactivate a tone, touch the Off button for that tone.
4. Touch the Reset button to restore the factory default setting
for the three tones.
5. Touch the Close button to return to the Machine Defaults 1
screen.
Guide to Performing Routine Maintenance