Exiting the Tools
mode
Setting the initial screen to display
Guide to Performing Routine Maintenance
3. Touch the Tools Pathway button on the screen to display the
Machine Defaults 1 screen.
Figure 7-3. Machine Defaults 1 screen
To exit the Tools mode, touch the Exit Tools button on the
Machine Defaults 1 or Machine Defaults 2 screen.
You can choose from two screens to display as the initial screen
when the printer is powered on:
•
Machine Status screen
•
Job Status screen
The Machine Status screen is the factory default.
Do not use the Job Status screen to perform job management
tasks such as holding, releasing, promoting, or deleting jobs.
Instead, use the printer controller for these functions.
To set the initial screen to display:
1. Access the Tools mode (refer to the section "Accessing the
Tools mode" in this chapter).
2. On the Machine Default 1 screen, touch the Initial Screen
button. The Initial Screen screen displays.
Default settings for the printer engine
CAUTION
7-3