Setting The Decurler - Xerox DocuColor 2060 Maintenance Manual

Default settings for the printer engine

Setting the decurler

7-24
6. To use these settings, exit the Tools mode and run the job
from the tray programmed.
Paper curl is caused by many variables:
• The manufacturer's brand of paper and the manufacturing lot.
• The weight of the paper, and if it is coated or uncoated.
• The amount of dry ink/toner and the area being covered on a
sheet. The heavier the coverage, the greater the tendency to
curl.
• The atmospheric conditions of the room where the paper is
stored.
• The atmospheric conditions of the room where the printer is
located.
• The heat generated during the fusing processes.
The printer is equipped with an automatic curl control system
that uses the variables listed above to determine the amount of
pressure needed at different decurlers to reduce the curl.
If you notice that output prints have too much curl, first try flipping
over the stack of paper in the paper tray being used. You can
also try running the job from a different tray. If curl is still a
problem, refer to the following tables to change the default
decurler settings.
Guide to Performing Routine Maintenance