Default settings for the printer engine
Setting the paper registration adjustment
7-14
Use the Paper Registration Adjustment setting when running
duplex jobs to adjust the image position if the registration is not
correct.
Image adjustment may be necessary for the following reasons:
•
Paper is not always the exact same size. It may vary slightly,
with differences of plus or minus 1mm, causing the image to
be is registered. To reduce the possibility of size differences,
it is recommend that you use paper from the same lot when
running duplex jobs.
•
During the fusing process, the heat and pressure applied to
the paper causes the paper to stretch. If the images on sides
one and two are the same size, the stretching of the paper
will cause the image on side one to be slightly larger than the
image on side two.
Guide to Performing Routine Maintenance