Cleaning The 4Mm Cartridge Tape Drive; Cleaning The Touch Screen - Xerox DocuColor 2060 Maintenance Manual

Cleaning

Cleaning the 4mm cartridge tape drive

Cleaning the touch screen

6-2
Clean the 4mm cartridge tape drive every 25 hours of actual tape
operation. Use only a cleaning cartridge designed for the 4mm
cartridge tape drive. No fluids or other preparations are
necessary with the use of these cartidges.
Do not use cleaning cartridges or any types of fluids designed for
use in audio devices as these can damage your tape drive.
To clean the tape drive:
1. Insert the cleaning cartridge into the tape drive as you would
a data tape cartridge.
2. Observe the green LED blinking slowly to indicate that the
tape drive is automatically performing a cleaning cycle.
NOTE: If the cleaning cartridge has been used for more than
approximately 30 cleaning cycles, the amber LED blinks
rapidly. Press the unload button to eject the cleaning
cartridge and discard it.
3. Remove the cleaning cartridge after it is automatically
ejected following the cleaning cycle.
You can use the cartridge tape drive immediately after cleaning.
Clean the touch screen during the printer warm-up cycle at the
start of each day. Remove all dust and fingerprints by wiping the
touch screen with a clean, lint-free cloth.
To avoid damage, do not use any Xerox cleaner, water, or
commercial cleaner on the touch screen.
CAUTION
CAUTION
Guide to Performing Routine Maintenance