Xerox WorkCentre Pro 412 User Manual page 159

Problem
Printing is too slow
Irregular faded
patches of print
Black staining
Character voids
Xerox WorkCentre Pro 412 User Guide
Probable Cause
The computer parallel
port may not be set for
high speed
communications.
If using Windows 95,
the spool setting may
be set incorrectly.
Computer may not
have enough memory
(RAM).
Print job is too large
There is a paper quality
problem.
Toner may be unevenly
distributed.
There is a paper quality
problem.
The paper may be too
dry.
Suggested Solution
If your computer is equipped with an
ECP parallel port, enable this mode of
operation. Refer to the Enabling High
Speed Printer Communications section
of your PC's user guide.
Point to the Start Task bar and then
click Settings, then Printers. Click your
product icon with the right mouse
button. Click Properties and then spool
settings on the Details tab. Select the
required setting from the available
choices.
Install more RAM in your computer.
Reduce resolution from 600 dpi to 300
dpi.
Use only paper that meets the
specifications required by the product.
Remove the toner cartridge and shake
it gently to distribute the toner evenly.
Then reinstall the toner cartridge.
Use only paper that meets the
specifications required by your product.
Try printing with a different batch of
paper.
Page 8-19