Xerox WorkCentre Pro 412 Service Manual

Hide thumbs Also See for WorkCentre Pro 412:

WorkCentre Pro 412

Launch Issue

SERVICE

MANUAL

Contents

1. Introduction

2. Service Call Procedures

3. Precautions

4. Specifications

5. Circuit Description

6. Disassembly

7. Maintenance & Troubleshooting

8. Exploded Views and Parts List

9. Electrical Parts List

10. Block Diagram

11. Connection Diagram

12. Schematic Diagrams

Part Number 708P86391

Table of Contents

Need help?

Do you have a question about the WorkCentre Pro 412 and is the answer not in the manual?

Page 1 WorkCentre Pro 412 Launch Issue SERVICE MANUAL Contents 1. Introduction 2. Service Call Procedures 3. Precautions 4. Specifications 5. Circuit Description 6. Disassembly 7. Maintenance & Troubleshooting 8. Exploded Views and Parts List 9. Electrical Parts List 10. Block Diagram 11.
Page 2 6-18 Main PBA ..........6-17 WorkCentre Pro 412...
Page 3 12-26 Toner TX Circuit Diagram ....... . . 12-26 WorkCentre Pro 412...
Page 4: Disassembly And Reassembly
5. Do not use force to remove or install plastic components. 6. Make sure all components are correctly installed. 6-2 Rear Cover 2. Separate the rear cover from the base frame and scanner assembly. 1. Remove the six screws securing the rear cover. WorkCentre Pro 412 Launch Issue...
Page 5: Maintenance And Troubleshooting
Loaded document has jammed Clear the document Jam. in the feeder when document jam occurred at ADF module DOOR OPEN The side cover is not securely Close the cover until it clicks in latched. place. WorkCentre Pro 412 Launch Issue...