Table of Contents
Advertisement
It is the specified device P2P login port or not when you are using P2P client.
Check username or password is right or not.
Check P2P SN is right or not. You can use the cell phone to scan the QR code on the device P2P
page (Main Menu > Network > P2P), or you can use the version information of the WEB to
confirm. (For some previous series products, the device SN is the main board SN, it might result
in error.)
35. I connect the standard definition camera to the device, there is no video output.
There are following possibilities:
Check the DVR supports standard definition signal or not. Only some series product supports
analog standard definition signal, coaxial signal input.
Check channel type is right or not. For the product supports analog standard definition
camera/HD camera, you need to go to the Main Menu > CAMERA > CHANNEL TYPE to select
corresponding channel type (such as analog) and then restart the DVR. In this way, the DVR can
recognize the analog standard definition.
Check camera power supplying, or camera data cable connection.
36. I cannot connect to the IP camera.
There are following possibilities:
Check DVR supports IP channel or not. Only some series products support A/D switch function, it
can switch analog channel to the IP channel to connect to the IP camera. From Main Menu >
CAMERA > CHANNEL TYPE, select the last channel to switch to the IP channel. Some series
product products support IP channel extension, it supports N+N mode.
Check the IPC and the DVR is connected or not. Go to the Main Menu > CAMERA >
REGISTRATION to search to view the IP camera is online or not. Or you can go to the Main Menu >
INFO > NETWORK > Network Test, you can input IP camera IP address and then click the Test
button to check you can connect to the IP camera or not.
Check IP channel setup is right or not (such as IP address, manufacturer, port, username, password,
and remote channel number).
Daily Maintenance
Use the brush to clean the board, socket connector and the chassis regularly.
The device shall be soundly earthed in case there is audio/video disturbance. Keep the device
away from the static voltage or induced voltage.
Unplug the power cable before you remove the audio/video signal cable, RS-232 or RS-485 cable.
Do not connect the TV to the local video output port (VOUT). It might result in video output circuit.
Always shut down the device properly. Use the shutdown function in the menu, or you can press
the power button in the front panel for at least three seconds to shut down the device. Otherwise
it might result in HDD malfunction.
Make sure the device is away from the direct sunlight or other heating sources. Keep the sound
ventilation.
Check and maintain the device regularly.
359
User's Manual
Advertisement
Table of Contents
