Table of Contents
Advertisement
Parameter
PTZ Linkage
Post-Alarm
Post Record
Anti-Dither
Snapshot
Record Channel
Tour
Alarm Tone
More Setting
Click Save to save the settings.
Description
Click Setting to display the PTZ page.
Enable PTZ linkage actions, such as selecting the preset that you want to
be called when an alarm event occurs.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will be
no delay.
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Configure the time period from end of event detection to the stop of
alarm.
Select the checkbox to take a snapshot of the selected channel.
To use this function, make sure the snapshot is enabled motion detect
alarms in Main Menu > STORAGE > Schedule > Snapshot.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm occurs.
The recording for IoT alarms and auto recording function must be
enabled. For details, see "5.1.4.9 Configuring Recorded Video Storage
Schedule" and "5.9.1 Enabling Record Control".
Select the checkbox to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured in Main
Menu > DISPLAY > Tour.
Select to enable audio broadcast/voice prompts in response to a
temperature alarm event.
Show Message: Select the Show Message checkbox to enable a pop-
up message in your local host PC.
Buzzer: Select the checkbox to activate a buzzer noise at the Device.
Video Matrix: Select the checkbox to enable the function. When an
alarm event occurs, the video output port outputs the settings
configured in Main Menu > DISPLAY > Tour.
This function is available on select models.
Send Email: Enable the system to send an email notification when an
alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Log: Select the checkbox to enable the Device to record a local alarm
log.
260
User's Manual
Advertisement
Table of Contents
