Table of Contents
Advertisement
Configure the settings for the HDD event.
Parameter
Description
In the Event Type list, select No Disk, Disk Error, or Low Space as the event
Event Type
type.
Enable
Enable or disable the HDD event detection function.
Click Setting to configure the parameters.
Alarm-out Port
Set a length of time for the Device to delay turning off alarm after the external
Post-Alarm
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and the
default value is 10 seconds.
Select the Show Message checkbox to enable a pop-up message in your local
Show Message
host PC.
Select the Report Alarm checkbox to enable the system to upload the alarm
Report Alarm
signal to the network (including alarm center) when an alarm event occurs.
Select the Send Email checkbox to enable the system to send an email
notification when an alarm event occurs.
Send Email
To use this function, make sure the email function is enabled in Main Menu >
NETWORK > Email.
Buzzer
Select the checkbox to activate a buzzer noise at the Device.
Disk
Table 5-33 HDD event settings
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
166
User's Manual
Advertisement
Table of Contents
