Table of Contents
Advertisement
Parameter
PTZ Linkage
Post Record
Tour
Picture Storage
Sub Screen
Video Matrix
Buzzer
Log
Alarm Tone
Warning Light
Siren
Click Apply to save the settings.
Click Default to restore the default setting.
Click Copy to, in the Copy to dialog box, select the additional channel(s) that you want
to copy the motion detection settings to, and then click Apply.
Click Test to test the settings.
Setting the Motion Detection Region
Next to Region, click Setting.
Point to the middle top of the page.
Description
Click Setting to display the PTZ page.
Enable PTZ linkage actions, such as selecting the preset that you want to
be called when an alarm event occurs.
Motion Detect can only activate PTZ preset.
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Select the Tour checkbox to enable a tour of the selected channels.
Select the Snapshot checkbox to take a snapshot of the selected channel.
To use this function, select Main Menu > CAMERA > Encode > Snapshot,
in the Type list, select Event.
Select the checkbox to enable the function. When an alarm event occurs,
the extra screen outputs the settings configured in Main Menu >
DISPLAY > Tour > Sub Screen.
This function is available on select models.
To use this function, extra screen shall be enabled.
Select the checkbox to enable the function. When an alarm event occurs,
the video output port outputs the settings configured in Main Menu >
DISPLAY > Tour.
This function is available on select models.
Select the checkbox to activate a buzzer noise at the Device.
Select the checkbox to enable the Device to record a local alarm log.
Select to enable audio broadcast/alarm tones in response to a motion
detection event.
Select the checkbox to enable warning light alarm of the camera.
Select the checkbox to enable sound alarm of the camera.
160
User's Manual
Advertisement
Table of Contents
