Table of Contents
Advertisement
Parameter
PIR Alarm
Schedule
Anti-Dither
Alarm-out Port
Post-Alarm
Show Message
Report Alarm
Send Email
Record Channel
Description
PIR function helps enhancing the accuracy and validity of motion detect.
It can filter the meaningless alarms that are activated by the objects such
as falling leaves, flies. The detection range by PIR is smaller than the field
angle.
PIR function is enabled by default if it is supported by the cameras.
Enabling PIR function will get the motion detect to be enabled
automatically to generate motion detection alarms; if the PIR function is
not enabled, the motion detect just has the general effect.
Only when the channel type is CVI, the PIR function can be enabled.
If the camera does not support PIR function, it will be unusable.
If the Device does not support PIR function, it will not be displayed
on the page.
Define a period during which the motion detection is active.
Configure the time period from end of event detection to the stop of
alarm.
Click Setting to configure the parameters.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds. If you enter 0, there will be
no delay.
Select the Show Message checkbox to enable a pop-up message in your
local host PC.
Select the Report Alarm checkbox to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.
Select the Send Email checkbox to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for motion detection and auto recording function must be
enabled. For details, see "5.1.4.9 Configuring Recorded Video Storage
Schedule" and "5.9.1 Enabling Record Control".
159
User's Manual
Advertisement
Table of Contents
