Table of Contents
Advertisement
Parameter
Alarm-out Port
Post-Alarm
Show Message
Report Alarm
Send Email
Record Channel
PTZ Linkage
Post Record
Tour
Picture Storage
Sub Screen
Description
Click Setting to configure the parameters.
Local Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
Extension Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 0 seconds to 300
seconds, and the default value is 10 seconds.
Select the Show Message checkbox to enable a pop-up message in your
local host PC.
Select the Report Alarm checkbox to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm event
occurs.
Select the Send Email checkbox to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > Email.
Select the channel(s) that you want to record. The selected channel(s)
starts recording after an alarm event occurs.
The recording for local alarm recording and auto recording must be
enabled. For details, see "5.1.4.9 Configuring Recorded Video Storage
Schedule" and "5.9.1 Enabling Record Control".
Click Setting to display the PTZ page.
Enable PTZ linkage actions, such as selecting the preset that you want to
be called when an alarm event occurs.
Set a length of time for the Device to delay turning off recording after the
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and
the default value is 10 seconds.
Select the Tour checkbox to enable a tour of the selected channels.
Select the Snapshot checkbox to take a snapshot of the selected channel.
To use this function, select Main Menu > CAMERA > Encode > Snapshot,
in the Type list, select Event.
Select the checkbox to enable the function. When an alarm event occurs,
the extra screen outputs the settings configured in Main Menu >
DISPLAY > Tour Setting > Sub Screen.
This function is available on select models.
To use this function, extra screen shall be enabled.
149
User's Manual
Advertisement
Table of Contents
