Table of Contents
Advertisement
Table 190 Advanced Application > ZULD Status
LABEL
Link State
Remote Operation
Remote MAC Addr
Remote Port
39.3 ZULD Configuration
Use this screen to enable ZULD on a port, configure a mode and set the probe time. To open this
screen, click Advanced Application > ZULD > Configuration.
Chapter 39 ZULD
DESCRIPTION
This field shows the following link states:
•
Linkdown: This is an initialization state, where the port is not yet up.
•
Probe: This indicates that ZULD is discovering the connected device on this link.
•
Bidirectional: Traffic sent by the Switch is received by the connected device on
this link, and traffic from the connected device on this link is received by the
Switch.
•
Unidirectional: The state of the link between the port and its connected port
cannot be determined either because no ZULD message was received, or one port
is not capable of sending traffic.
•
Shutdown: The port has been shut down because its link with the connected
device is unidirectional and ZULD is in Aggressive mode.
This field displays whether ZULD is enabled or disabled on the connected device on
this link. ZULD must be enabled on the connected device and on the port that's
connecting to the Switch.
This is the MAC address of the port on the connected device to which the port of the
Switch is connected.
This is the port number of the port on the connected device to which the port of the
Switch is connected.
GS3700/XGS3700 Series User's Guide
393
Advertisement
Table of Contents
