Table of Contents
Advertisement
Table 86 Advanced Application > Classifier > Classifier Configuration (continued)
LABEL
DESCRIPTION
Weight
Enter a number between 0 and 65535 to specify the rule's weight. When the match order is in
manual mode in the Classifier Global Setting screen, a higher weight means a higher
priority.
Log
Select this option to have the Switch create a log message when the rule is applied and record
the number of matched packets in a particular time interval.
Note: Make sure you also enable logging in the Classifier Global Setting screen.
Count
Select this option to have the Switch count how many times the rule is applied.
Tme Range
Select the name of the pre-configued schedule that you want to apply to the rule. The rule will
be active only at the scheduled date and/or time.
If you select None, the rule will be active all the time.
Ingress Port
Port
Type the port number to which the rule should be applied. You may choose one port only or all
ports (Any).
Trunk
Select Any to apply the rule to all trunk groups.
To specify a trunk group, select the second choice and type a trunk group ID.
Packet
Specify the format of the packet. Choices are All, 802.3 tagged, 802.3 untagged,
Format
Ethernet II tagged and Ethernet II untagged.
A value of 802.3 indicates that the packets are formatted according to the IEEE 802.3
standards.
A value of Ethernet II indicates that the packets are formatted according to RFC 894,
Ethernet II encapsulation.
Layer 2
Specify the fields below to configure a layer-2 classifier.
VLAN
VLAN
Select Any to classify traffic from any VLAN or select the second option and specify the source
VLAN ID in the field provided.
Inner
Select Any to classify traffic from any inner VLAN (the customer's VLAN) or select the second
VLAN
option and specify the source VLAN ID in the field provided.
Priority
Priority
Select Any to classify traffic from any priority level or select the second option and specify a
priority level in the field provided.
Inner
Select Any to classify traffic from any inner priority level or select the second option and
Priority
specify a priority level in the field provided.
Ethernet Type Select an Ethernet type or select Others and enter the Ethernet type number in hexadecimal
value. Refer to
Source
MAC Address
Select Any to apply the rule to all MAC addresses.
To specify a source, select MAC/Mask to enter the source MAC address of the packet in valid
MAC address format (six hexadecimal character pairs) and type the mask for the specified
MAC address to determine which bits a packet's MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should match.
Enter "0" for the bit(s) of the matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and the mask to
ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this criteria. If
you leave the Mask field blank, the Switch automatically sets the mask to ff:ff:ff:ff:ff:ff.
Destination
Chapter 19 Classifier
Table 88 on page 206
for information.
GS3700/XGS3700 Series User's Guide
204
Advertisement
Table of Contents
