Table of Contents
Advertisement
Figure 233 Advanced Application > PPPoE > Intermediate Agent > VLAN
The following table describes the labels in this screen.
Table 156 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL
DESCRIPTION
Show VLAN
Use this section to specify the VLANs you want to configure in the section below.
Start VID
Enter the lowest VLAN ID you want to configure in the section below.
End VID
Enter the highest VLAN ID you want to configure in the section below.
Apply
Click Apply to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified above. If you configure
the * VLAN, the settings are applied to all VLANs.
*
Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Note: Changes in this row are copied to all the VLANs as soon as you make them.
Enabled
Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Circuit-id
Select this option to make the Circuit ID settings for a specific VLAN take effect.
Remote-id
Select this option to make the Remote ID settings for a specific VLAN take effect.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Chapter 30 PPPoE
GS3700/XGS3700 Series User's Guide
324
Advertisement
Table of Contents
