Table of Contents
Advertisement
®
R&S
NRPM
This function makes sure, that a new measurement only starts after all sensor modules
have completed their last measurement.
Make sure that the number of repetitions is the same for all the sensor modules
involved in the measurement. Otherwise, the trigger bus is blocked by any sensor
module that has completed its measurements before other sensor module and has
returned to the IDLE state.
Parameters:
<state>
7.9 Using the Status Register
Further information:
●
Chapter A.2, "Status Reporting
Contents:
●
●
●
●
●
●
7.9.1 General Status Register Commands
Remote commands:
STATus:PRESet
Resets the edge detectors and ENABle parts of all registers to a defined value.
Usage:
STATus:QUEue[:NEXT]?
Queries the most recent error queue entry and deletes it.
Positive error numbers indicate sensor module specific errors. Negative error numbers
are error messages defined by SCPI.
If the error queue is empty, the querry returns 0 ("No error").
Usage:
User Manual 1425.8663.02 ─ 05
*RST:
OFF
System",
Commands...................................................................... 97
Part............................................................................ 98
Part...................................................................................98
Part....................................................................................98
...............................................................................................................97
.................................................................................................. 97
Event
Query only
Using the Status Register
on page 116
Part................................................................. 99
Part................................................................. 100
Remote Control
97
Advertisement
Chapters
Table of Contents
