Commands For Test, Alignment, And Diagnosis - Rohde & Schwarz R&S FSW-K30 User Manual

®
R&S FSW-K30
7.15.3.2

Commands for test, alignment, and diagnosis

The following commands are required to test and optimize the connection after it has
initially been set up.
[SENSe:]EFRontend:ALIGnment<ch>:FILE
[SENSe:]EFRontend:ALIGnment<ch>:STATe
[SENSe:]EFRontend:FWUPdate
[SENSe:]EFRontend<fe>:SELFtest?
[SENSe:]EFRontend<fe>:SELFtest:RESult?
[SENSe:]EFRontend:ALIGnment<ch>:FILE <File>
Selects or queries the touchstone file that contains correction data to compensate for
signal losses in the cable occurring at different IF signal frequencies.
Suffix:
<ch>
Parameters:
<File>
Example:
[SENSe:]EFRontend:ALIGnment<ch>:STATe <State>
Activates correction of the IF signal due to cable loss from the frontend to the analyzer.
Specify the file with correction data using
FILE
Suffix:
<ch>
Parameters:
<State>
User Manual 1173.9270.02 ─ 31
Remote control commands for noise figure measurements
.
1..n
Currently irrelevant
string in double quotes
Path and file name of the correction data file. The file must be in
s2p format.
If the specified file is not found or does not have the correct for-
mat, an error message is returned (-256, "File name not
found", -150, "String data error").
EFR:ALIG:FILE "FE44S.s2p"
on page 204.
.
1..n
Currently irrelevant
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST:
Configuring the inputs and outputs
...................................................................... 204
.................................................................... 204
......................................................................................205
................................................................................ 205
..................................................................... 205
[SENSe:]EFRontend:ALIGnment<ch>:
0
204