Status Subsystem; Status Operation Register; Measure:trigger:delay; Measure:voltage - Rohde & Schwarz R&S LCX Series User Manual

www.allice.de
®
R&S LCX Series

11.14 STATus subsystem

11.14.1 Status operation register

User Manual 1179.2260.02 ─ 02
MEASure:TRIGger:DELay <Trigger Delay>
Sets a delay time that elapses after a trigger event before the measurement starts.
Parameters:
<Trigger Delay> Range:
*RST:
Default unit: s
Example: See
Manual operation: See

MEASure:VOLTage?

Queries the voltage value following next in the measurement.
Example: See
Usage: Query only

READ?

Queries the measurement results for measurement pair 2.
Example: See
Usage: Query only

READ:IMPedance?

Queries the impedance measurement results.
Example: See
Usage: Query only
This system contains the commands for the status reporting system, see
ter 10.2.4, "Status reporting
registers.
This system contains the commands for controlling the STATus:OPERation register
of the status reporting system.
0 s to 60 s
0 s
Example "Using the MEASure commands"
"Trigger Delay" on page 77
Example "Using the MEASure commands"
Example "Acquiring measurement readings"
Example "Acquiring measurement readings"
system", on page 146.
Allice Messtechnik GmbH
Remote control commands
STATus subsystem
on page 205.
on page 205.
on page 206.
on page 206.
Chap-
has no effect on the status
*RST
208