Table of Contents
Advertisement
EH
/ SOC. HD...
区 JALLINCKRODT
INTRODUCTION
GENERAL
The following is intended to facilitate the procurement of parts applicable to the CT 9000® ADV
Digital Injection System
with a 115-volt chassis.
PRODUCT STRUCTURE DIAGRAM
The Product Structure Diagram, on page iv is a tree-structured diagram listing all major assemblies under the three
main components constituting the CT 90000 ADV Digital injection System. The three main components are:
* Power Pack Assembly
* Powerhead
* Console
GROUP ASSEMBLY PARTS LISTS
The Group Assembly Parts List, Sections 1 through 4, consists of the complete end item, divided into its major
assemblies, subassemblies, and component parts. See Table of Contents.
It has five columns: Figure and Index
Number, Part Number, Description, Units per Assembly and Component Designator (used io highlight individual
components on printed circuit boards.)
FIGURE & INDEX NUMBER COLUMN
The first number in this column, preceding a dash, indicates the figure number, and the number following the dash
indicates the index for that particular illustration.
PART NUMBER COLUMN
This column contains the identification number of the assembly, subassembly, or component by which it may be
procured.
DESCRIPTION COLUMN
This column contains the nomenclature and/or description of the assemblies, subassemblies or components used in
/ the end item. References are made to next higher assemblies, and to subassemblies that are further disassembled.
Each assembly or subassembly is followed by its component parts, properly indented thereunder, to show their
relationship to the assembly or subassembly.
The attaching parts for the assembly, subassembly, or component
immediately follow the part they attach in the same indentation.
UNITS-PER-ASSEMBLY COLUMN
The quantities listed in this column are the total used at the location shown and are not necessarily the total used on
the end item.
COMPONENT DESIGNATOR COLUMN
This column is used to list ail individual components on printed circuit boards that match the description. For example,
a particular diode or capacitor may be used a number of times in different locations on the same board. To determine |
the specifications of a particular component, simply find it in the Component Designator column, then read the
description.
FIG. NO. SUFFIX COLUMN
Complex assemblies may require multiple illustrations. These illustrations share a common figure number but are
differentiated by a figure-number suffix (e. g. Fig. 2-1-a, Fig. 2-1-b, etc.). The suffixes listed in this column indicate
in which illustration each item is shown.
ABBREVIATIONS
The following are abbreviations used in this parts catalog.
BRACKET
SLOTTED
TRUSS HEAD
«PAN HEAD
.... SOCKET SET
....STAINLESS STEEL
. MACHINE SCREW
BRACKET
SOC. CAP.
800961-C
Sept. 2000
iii
Advertisement
Table of Contents
