Preparing The Felt - Epson ML-13000 User Manual

ML-13000 User's Manual

Preparing the Felt

Prepare some felt to soak up the glue remover.
When using the felt that comes with the machine
A
Put the felt rod through the glue-removal felt.
When using commercially available felt
Make a loop out of the felt and sew it in place
A
As shown in the figure, fold the felt so that it is approximately 70 mm wide, and then sew three points (the
left, right, and center) of approximately 100 mm to form a loop.
B
Put the felt rod through the felt.
Maintenance
302