Epson ML-13000 User Manual page 338

ML-13000 User's Manual
❏ Entire belt
Circle the belt once to check for any obvious unevenness on the belt surface.
Unevenness as shown in the figure below may result in poor print quality.
A
Unevenness on the belt surface
If there is any unevenness, remove and reapply the glue.
The condition shown below, where the glue applied to the belt is partially peeling off, occurs when the soapy
water is applied too late or it dries up in the middle of the process. However, this does not affect the adhesion
of the glue.
Maintenance
338