Belt Surface Cleaning - Epson ML-13000 User Manual

ML-13000 User's Manual
M
If glue partially remains, soak the felt with glue remover again to make the hardened glue rise, and then
scrape it away.
N
Touch the Suspended - Done buttons on the control panel in that order.
Check the message displayed on the control panel. Touch Yes to continue glue application, or No to
discontinue glue application.
If you apply glue at this stage, do not return to the home screen, and leave the mode selection screen as it is.

Belt surface cleaning

Clean the surface of the belt once.
A
Press the Feed or Backfeed button on the front panel to rotate the belt.
B
Wipe off the glue until the belt surface is polished.
When the wipe cloth is dirty or glue chips occur, it means glue remains on the belt.
Dispose of used wipe cloths and glue chips according to the laws and regulations in your country.
c
Important:
Glue tends to remain on the belt edges, so focus on peeling those areas. If glue or other such material is stuck
to the edge of the belt, it may not be possible to measure the normal belt feed rate.
Maintenance
312