Epson ML-13000 User Manual page 289

ML-13000 User's Manual
A
Handles
B
Check if there is water in the cleaning tank.
Supply water if it is not already accumulated.
C
Push the belt cleaning unit back to its original position.
D
Close the front cover.
E
From the Maintenance screen on the control panel, touch Maintenance - Belt Cleaning, in that order.
F
Touch Belt speed on the Belt Cleaning screen, and then touch Normal.
G
Touch OK at the top-right of the Belt speed screen.
Set the belt rotation speed to Normal.
H
Touch Number of cleaning cycles, and then touch + or - to set the number of cleaning cycles to 3.
I
Touch OK at the top-right of the Number of cleaning cycles screen.
The number of cleaning cycles is set to three.
J
Check the message on the Belt Cleaning screen, and then touch Start.
Belt cleaning begins.
K
When belt cleaning is complete, use water soaked wipe cloths to wipe off any water droplets or remaining
remover on the belt surface.
L
Check the on-screen message, and then touch OK.
Maintenance
289