Replacement of the TM-T88V
The TM-T88VI is designed so that it can smoothly replace the TM-T88V. This chapter describes precautions for
the replacement.
Compatibility
Printing
The printing and character specifications are the same as those of the TM-T88V. Without special
configurations, the TM-T88VI prints the same results as the TM-T88V prints.
Print Density
The print density of the TM-T88VI can be set with DIP switches (2-3/2-4) as can the TM-T88V. Set the density
the same as for the TM-T88V to print in the same print density.
Number of Head Energizing Parts
For the TM-T88VI, the default setting of the number of head energizing parts is "One-part energizing. " It does
not usually need to be changed.
Number of head energizing part
Printable Area (for 80 mm Width Paper)
The printable area (left/right margins, print start position from the autocutting position, print start position
from the manual cutting position) of the TM-T88VI is the same as that of the TM-T88V.
Cutting Method
The TM-T88VI uses the partial cutting method (cutting with one point in left edge left uncut) as does the TM-
T88V.
Manual Paper Feed
As same with the TM-T88V, manual paper feed is not possible with the TM-T88VI.
TM-T88VI
One-part energizing
Two-part energizing
Four-part energizing
Chapter 6 Replacement of the TM-T88V
TM-T88V
One-part energizing
Two-part energizing
Four-part energizing
6
103