Do the following to reduce creasing:
• Set the Feeding Tension setting to Manual and increase the tension values.
• Set the Take-up Tension setting to Manual and decrease the tension values.
• Attach a spacer in the slot of the media loading lever.
Parent topic:
Related references
Media Setup Menu Settings
Printing Continues After Media Roll Empties
If printing does not stop when the media roll ends, make sure the Media End Check setting is set to On.
For best results, leave this setting turned on.
Parent topic:
Related references
Printer Setup Menu Settings
Removing Jammed Media
If media jams in the printer, check the following:
• Make sure the media is not curled, creased, or folded on the leading edge. Do not use media in poor
condition.
• Check the media specifications to make sure you can use the media with your printer and your RIP
software. Check the RIP software manufacturers media guidelines.
• Set the Media Suction setting to a lower value on the product control panel.
Follow the steps here if media becomes jammed in the product.
1. Open the front cover.
Solving Printing Problems
Solving Printing Problems
158