Section 7 Maintenance; Pre-Maintenance Check; Maintenance Equipment; Table 7-1 Equipment Recommended For Maintenance - Will Burt EXPEDITION RANGER MAST Operator's Manual

Section 7
This section describes maintenance procedures required to keep the mast system operational.
Use care to understand and follow all precautions while performing these procedures. If the
system does not perform as required, contact The Will-Burt Company.
Disconnect power to any devices mounted to the mast with lock-out tagout procedures as
appropriate before performing mast maintenance.

7.1 Pre-Maintenance Check

Before performing maintenance procedures, ensure:
•
All operators read and understand the entire maintenance procedure and are properly
trained.
•
The payload is removed prior to performing maintenance on the system.
•
The system is level and secure.

7.2 Maintenance Equipment

Table 7-1 lists recommended equipment for maintenance.
Personal Protective
Safety Glasses
Hard Hat or Helmet
Hand Tools
Hammer
Level
Torque Wrench
Expendables
Non-Abrasive Cleaners
(Soap and Water)
* Note:
•
Depending on the local, regional, and national standards and codes of practice, and the environment, additional
personal protective equipment may be necessary.
•
When disposing of any disposables or components, do so according to any applicable local, regional, and national
standards and codes of practice.
TP-4549901-G
February 2024
Maintenance

Table 7-1 Equipment Recommended for Maintenance

Tools and Materials*
Safety Gloves
Hearing Protection
Hex Wrenches
Screwdrivers
Utility Knife
Rags (Clean and
Dry)
™ M
R
ANGER AST
Safety Shoes Nitrile or Vinyl Gloves
Plumb Bob Measuring Tape
Sockets Wrenches
'
O M
PERATOR S ANUAL
7-1